
Green Drake Fripple
Green Drake Fripple is Curtis Fry's drake-sized take on the Fripple 2.0 from Fly Fish Food. Deer hair replaces the snowshoe hare used on the smaller version, and a wrapped hackle adds float and a bigger footprint. The rear of the curved hook slices through the surface so the ribbed, coated abdomen hangs below the film, while the foam thorax rides in it. Cast it to likely holding water before and during green drake and gray drake hatches. The same approach adapts to other large mayflies. Tied here on a size 10 hook.
Ready to tie this?
This pattern needs 9 materials. Sign up free to check which ones you already own.
Materials
Daiichi 1160 Klinkhammer Hook, size 10
10
Danville Flat Waxed Nylon 70 denier, fluorescent fire orange, for the hot spot
Fluorescent Fire Orange · 70 denier
Danville Flat Waxed Nylon 70 denier, olive, for the body and the rest of the fly
Olive · 70 denier
Loon Fluorescing UV Clear Fly Finish, to coat the abdomen
Medallion Sheeting, buggy light dun
Buggy Light Dun
Nature's Spirit All Purpose Deer Hair 2" x 3", olive, for the overwing
Olive
Barred olive dry fly hackle feather
Barred Olive
How to Tie the Green Drake Fripple
- 1
Step 1
Mount the hook and start the fire orange thread well down the bend. Wrap a short, neat band as a hot spot at the rear of the body, then tie off and cut the thread.
- 2
Step 2
Start the olive thread just ahead of the orange band and tie in a length of green tinsel.
- 3
Step 3
Wrap the olive thread forward in a smooth, slim body up the bend to where the shank straightens.
- 4
Step 4
Wind the tinsel forward in open spirals for the rib. Tie it off at the front of the body and trim the excess.
- 5
Step 5
Coat the abdomen with a thin layer of UV finish and cure it.
- 6
Step 6
Cut a short length of the foam. Tie it on top of the shank at its center, ahead of the abdomen, so one end points forward and the other points back. Pull the thread down firmly so the wraps cut a waist into the foam.
- 7
Step 7
Cut a piece of Medallion Sheeting for the wings and tie it in at the rear of the foam so it sweeps back over the abdomen. Trim it to a rounded wing shape.
- 8
Step 8
Trim the two foam ends so they form a rounded lump on each side of the waist.
- 9
Step 9
Clean and stack a small bunch of olive deer hair. Tie it on top at the foam waist so the tips fan up and back, then trim the butts.
- 10
Step 10
Tie in the hackle feather at the waist. Wrap it around the middle of the foam, tie it off and trim the tip.
- 11
Step 11
Work the thread to the eye and whip finish. Trim any fibers that get in the way of the eye.
Watch Tying Tutorial
https://www.youtube.com/watch?v=27M_NKMkEkU
Credit: Curtis Fry / Fly Fish Food