
Poptimus Prime
Poptimus Prime is Cheech's fix for the topwater dorado strikes he missed on his first trip, when the flies he had on offered too little hook gap. A foam popper head glued to a Gamakatsu B10S Stinger leaves the hook open, and the fly stays very light and easy to cast. A long tail of Steve Farrar SF Blend, a little Squishenille and a black Craft Fur Brush collar give it length and bulk with few steps. Colors are easy to change with a white head or a purple brush. Tied here on a size 5/0 hook.
Ready to tie this?
This pattern needs 8 materials. Sign up free to check which ones you already own.
Materials
210 Denier Waxed Danville Flymaster Plus, black #11 (or UTC Ultrathread 210 Denier, black)
Black · 210 denier
Steve Farrar SF Blend, UV rainbow (or Flash 'N Slinky, mullet brown)
UV rainbow
Steve Farrar SF Blend, UV black (or Flash 'N Slinky, black)
UV black
EP Craft Fur Brush, 3 inch, black/black (or black/purple)
Black/black · 3 inch
Double Barrel Popper Bodies, extra large, black (or white)
Black · Extra large
Loctite Gel Control Super Glue, for fixing the head
How to Tie the Poptimus Prime
- 1
Step 1
Start the black thread on the hook and lay a firm base along the shank to the bend.
- 2
Step 2
Pull a long bunch of UV rainbow SF Blend, tie it in at the rear of the shank near its middle and fold the forward half back for the tail. Bind it down.
- 3
Step 3
Tie in the Medium Badger Flexi Squishenille ahead of the tail and wrap a short section forward. Tie it off, trim it and stroke the fibers back.
- 4
Step 4
Tie a bunch of UV black SF Blend on top ahead of the chenille the same way, folding it back so it lies over the rainbow fibers.
- 5
Step 5
Tie in the EP Craft Fur Brush ahead of the black fibers and wrap it forward, stroking the fibers back so none get trapped.
- 6
Step 6
Tie off the brush a little behind the eye and trim the wire core. Leave enough bare shank for the popper head.
- 7
Step 7
Open the hole in the popper body with a bodkin if it is tight, then push the body over the eye to check how it sits. Slide it back off.
- 8
Step 8
Wrap a thread base on the bare shank behind the eye and whip finish.
- 9
Step 9
Run a little Loctite Gel Control Super Glue into the hole in the popper body.
- 10
Step 10
Slide the body over the eye, narrow end forward, until it seats against the fibers. Hold it straight until the glue grabs.
Watch Tying Tutorial
https://www.youtube.com/watch?v=qaN_gmrBqVI
Credit: Cheech / Fly Fish Food